Cabot's Exterior Clear is a durable, marine grade polyurethane that provides protection and shine without hiding the grain. It provides resistance against weathering and moisture damage and contains the latest ultra-violet absorber technology to maximise gloss, performance and durability.

PREPARATION

Note: Fill holes and imperfections with a suitable timber putty if required.

Bare Timber

To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions. Remove excess water from the surface with squeegee on Cabot’s Deck Prep brush, and allow timber to dry for at least 1 hour. Note: Cooler conditions could slow down the drying time of the timber.

Previously Stained and Oiled Timber

For exterior surfaces clean with Cabot’s Deck Clean following label instructions. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of Deck Clean. If water is absorbed into timber, it is ready for coating. For a more transparent look, sand timber back to bare then clean with Cabot's Deck Clean before coating.

Weathered and Grey Timber

For best results, sand timber back to fresh substrate. Clean with Cabot's Deck Clean following label instructions.

APPLICATION

Important - work in a well ventilated area and protect nearby surfaces from overspray.

1. Before spraying, shake can well for about 1 minute, ensure the mixing ball is moving vigorously inside the can.
2. Hold can approximately 20cm away from the surface. Apply light coats with a quick even motion, beginning and ending each stroke beyond the surface being sprayed until the desired finish is achieved.

Note: For exterior timber a minimum of 4 coats is recommended, depending on porosity of timber. Clear the nozzle after each use by turning the can upside down and spray for several seconds.